V2U3X4-PCIE1XE101
2-port USB 3.0 to PCI Express x1 Gen2 Host Card
Main > Product > Frame Grabbers & Interface Cards > USB3 Frame Grabber > PCIe x1 > V2U3X4-PCIE1XE101
V2U3X4-PCIE1XE101
The V2U3X4-PCIE1XE101 is a Quad channel USB 3.0 to PCI Express x1 Gen 2 Host Card. V2U3X4-PCIE1XE101 is designed with Two key components.
Utilizing the standard PCI Express Switch, the 5-Lane/5-Port PCI Express Switch provides the most efficient fan-out solution for integrating four PCI Express to USB 3.0 Single Chip Host controllers into a small board design. Each USB 3.0 to PCI Express Single Chip Host controller takes advantages of 5 Gbps burst rate of 1-lane PCI Express bus in both directions and is fully compliant with PCI Express Base specification r2.0. This solution provides full PCI Express and USB 3.0 functionality and performance. |
The Highlight Features
- Host Bus: PCIe x1 Gen 2 (5.0 Gb/s)
- Compliant with PCI Express Base Specification Revision 2.0
- Four independent USB 3.0 Host Controllers
- Compliant with Universal Serial Bus 3.0 specification Revision 1.0
- Compliant with Intel’s eXtensible Host Controller Interface (xHCI) specification Revision 1.0
- Supports USB Battery Charging Specification Revision 1.2 for Charging Downstream Ports (CDP).
- Four USB 3.0 Cable Ports (A-type Receptacle)
- Provides USB 3.0 cable port lock mechanism
Model | V2U3X4-PCIE1XE101 |
---|---|
Primary PCI Express | Standards compliant PCI Express Base Specification r2.0 (Backwards compatible with PCIe r1.0a/1.1) PCI Power Management Spec r1.2 Microsoft Vista®-compliant Supports Access Control Services Dynamic Link-width control Dynamic SerDes speed control High Performance Non-Blocking Internal architecture Full line rate on all Ports Cut-Thru latency: 130ns 2KB max payload size PCI Express Power Management Link power management states: L0, L0s, L1, L2/L3 Ready, and L3 Device states: D0 and D3hot Quality of Service (QoS) support Two Virtual Channels (VC) per Port Eight Traffic Classes per Port Weighted Round-Robin Port & VC Arbitration |
Secondary PCI Express | Single (x1) PCI Express Lane Compliant with PCI Express Base Specification Revision 2.0 Supports PCI Express Card Electromechanical Specification Revision 2.0 Supports PCI Bus Power Management Interface Specification Revision 1.2 |
USB Features | Compliant with USB 3.0 Specification Revision 1.0 Compliant with Intel’s eXtensible Host Controller Interface (xHCI) specification Revision 1.0 Each USB port supporting SS/HS/FS/LS data rates (5Gbps/480Mbps/12Mbps/1.5Mbps) Supports USB Battery Charging Specification Revision 1.2 for Charging Downstream Ports (CDP). |
USB Data Transfer Rate | Low-speed (1.5 Mbps) Full-speed (12.0 Mbps) High-speed (480.0 Mbps) Super-speed (5.0 Gbps) |
Number of Ports | Four independent USB 3.0 Cable Ports (A-type Receptacle) |
USB Bus Power Input | Either Big IDE 4-pin DC Power Connector or/and SATA 15pin Power Connector |
Computer with PCI Express slot (x1, x4, x8, x16)
Note:
For the best performance (5.0 Gbps), It should be installed in a PCIe Gen 2 compliant slot in the host computer. Most computers have PCIe Gen 2 (5.0 Gbps) throughput on x8 or x16 slots.
A PCIe Gen 1 compliant slot reaches up to 2.5 Gbps throughput
- 139mm(W) x 101mm[120mm](H)
- NW: 99.3g
- If OS is Windows 8 or later , there are inbox driver for Renesas USB 3.0 Host Controller. OS will detect the presence of new hardware and then install Renesas USB 3.0 Host Controller driver automatically.
- USB 3.0 Host Drivers Kit (x86 and x64) for
- Windows XP
- Windows Vista
- Windows 7
- Windows Server 2008 Release 2
- CE Test: Pass
- FCC Test : Pass
- VCCI Test: Pass