V2U31X4-PCIE8XE101

Octad Channel 8-port (1-port x 8) USB 3.0 (USB 3.1 Gen 1) to PCI Express x8 Gen 2 Host Card

Main > Product > Frame Grabbers & Interface Cards > USB3 Frame Grabber > PCIe x8 > V2U31X4-PCIE8XE101

V2U31X4-PCIE8XE101

V2U3X8-PCIE8XE111 is integrated by the following three key parts (V2IP8X-PCIE8XG201,V2DU3X2-IPCIE2XG211, V2CB-00592).

V2IP8X-PCIE8XG201
- Internal eight PCIe x1 to PCIe x8 Gen 2 Switch Host Card.
Two V2DU3X2-IPCIE2XG211
- Four PCI Express x1 to USB 3.0 Single Chip Host Controllers ( FRESCO FL1100; USB IF TID 380000026).
Four V2CB-00592

Utilizing the standard PCI Express Switch, the 16-Lane/16-Port PCI Express Switch provides the most efficient fan-out solution for integrating Sixteen PCI Express to USB 3.0 Single Chip Host controllers into a small board design. Each USB 3.0 to PCI Express Single Chip Host controller takes advantages of 5 Gbps burst rate of 8-lane PCI Express bus in both directions and is fully compliant with PCI Express Base specification r2.0. This solution provides full PCI Express and USB 3.0 functionality and performance.

The Highlight Features

Host Bus: PCIe x8 Gen 2 (40.0 Gb/s)
- Compliant with PCI Express Base Specification Revision 2.0
Eight independent USB 3.0 Host Controllers
- Compliant with Universal Serial Bus 3.0 specification Revision 1.0
- Compliant with Intel’s eXtensible Host Controller Interface (xHCI) specification Revision 1.0
- USB 3.0 Host Controller supports four downstream ports
thirty-two USB 3.0 Cable Ports (A-type Receptacle)
- Provides USB 3.0 cable port lock mechanism
USB 3.0 Standard A-type lock mechanism
Dual 5.25″ ODD Form Factor (DU3X2-IPCIE2XG211 )

Specifications

Model	V2U31X4-PCIE8XE101
PCI Express	1. Two SFF-8643 Connectors o 85ohm, 36pin (pitch=0.75) 2. Each SFF-8643 Connector 4-lane PCI Express o PCIe Gen 1 (2.5 GT/s) o PCIe Gen 2 (5.0 GT/s) o PCIe Gen 3 (8.0 GT/s)
USB Features	• Up to USB 3.1 Gen 2 10Gbps • Compliant with Universal Serial Bus 3.1 Specification Revision 1.0 • Compliant with Universal Serial Bus Specification Revision 2.0 • Compliant with USB Attached SCSI Protocol Revision 1.0 • Support Multiple INs function • Support USB 3.1 and USB 2.0 Link Power Management • Support Control, Bulk, Stream, Interrupt, Isochronous transfer type • Support independent port power control • Support overcurrent detection • Support Remote/Wakeup event • Integrate Spread Spectrum Controller for USB3.1 interface • Backward compatible with Legacy USB function and device • Support the Debugport
USB3 cable lock mechanism	Provides the threaded holes for the jack-screws of USB 3.1 A Plug w/Jackscrew lock Cable
Number of Ports	Eight USB 3.1 (Standard A-type Receptacle) cable ports
USB Bus Power Input	DC 12V (Step-Down) from either Big IDE 4-pin DC Power Connector or/and SATA 15pin Power Connector

Computer Platform

Computer with PCI Express slot ( x8, x16)

Note:
For the best performance (5.0 Gbps), It should be installed in a PCIe Gen 2 compliant slot in the host computer.

Operating System Requirements

If OS is Windows 8 or later , there are inbox driver for Renesas USB 3.0 Host Controller. OS will detect the presence of new hardware and then install Renesas USB 3.0 Host Controller driver automatically.
USB 3.0 Host Drivers Kit (x86 and x64) for
- Windows XP
- Windows Vista
- Windows 7
- Windows Server 2008 Release 2

Firmware, Drivers, Utility

Driver Download

Version:	3.6.8.0		2015/8/4
Content:	USB 3.0 Host Controller Driver Kit (x86 and x64) For Windows XP, VISTA, 7, 8 and 8.1		Download

* Specifications subject to change without prior notice

V2U31X4-PCIE8XE101

Octad Channel 8-port (1-port x 8) USB 3.0 (USB 3.1 Gen 1) to PCI Express x8 Gen 2 Host Card

Main > Product > Frame Grabbers & Interface Cards > USB3 Frame Grabber > PCIe x8 > V2U31X4-PCIE8XE101